Description
G3ENET00 Product Manual
POWER REQUIREMENTS:
Power is supplied to the option card from the main board of your G3 operator
interface.
COMMUNICATIONS:
Ethernet Port: 10 BASE-T / 100 BASE-TX
RJ45 jack is wired as a NIC (Network Interface Card).
ENVIRONMENTAL CONDITIONS:
Operating Temperature Range: 0 to 50 °C
Storage Temperature Range: -20 to 80 °C
Operating and Storage Humidity: 80% maximum relative humidity (noncondensing)
from 0 to 50 °C.
Altitude: Up to 2000 meters.
CONSTRUCTION: Installation Category I, Pollution Degree 2.
INSTALLATION REQUIREMENTS: Card must be installed inside the
rear cover of a G3 operator interface with the hardware provided. See
“Installing the G3ENET Option Card” for more details.
CERTIFICATIONS AND COMPLIANCES:
ELECTROMAGNETIC COMPATIBILITY
Emissions and Immunity to EN 61326: Electrical Equipment for Measurement, Control and Laboratory use.
Immunity to Industrial Locations: Reference G3 unit for emissions and immunity specifications
WEIGHT: 1.6 oz (45.36 g)
GENERAL DESCRIPTION
This is an Ethernet Option card for G3 operator interfaces.
The G3 proprietary expansion slot provides a high speed, parallel architecture that extends the functionality and flexibility of the G3 series HMI. This approach allows the G3 series to evolve concurrently with the latest advances in
communications and standards, without sacrificing performance. This high bandwidth channel has significantly greater throughput when compared to the traditional (external) serial gateway approach.
The G3NET00 option card is easily installed by removing the rear cover of your G3 operator interface, attaching the card using the supplied screws and connecting a single cable. Installing this card adds an auxiliary 10/100 Ethernet
port to any G3 Series HMI that contains only a single resident port. The auxiliary Ethernet port provides a means to isolate machine-network traffic from the plant-wide network, thereby negating the need for an industrial router. Further, by isolating the machine and plant-wide networks, the system only requires that a single IP address be provided by the company’s IT group.
- Ethernet Option Card for G3 Operator Interface Terminals
- Configured using Crimson® software
- 10/100 Base-Tx Ethernet Port
- Installs Inside a G3 Operator Interface Terminal
- Installation and connection hardware included with card
- For use in G3 Units with one Ethernet Port
